WARNINGS

• To reduce the risk of injury, charge only 42V with the charger. Do not charge a non-rechargeable battery. Other types of batteries might burst, causing personal injury or other damage!

• Do not disassemble the charger. Have it serviced or repaired by qualified service personnel. Incorrect assembly can result in risk of electric shock or fire.

• Never use the charger as a DC power source for any electrical equipment.

• Never operate a charger with a damaged cord or plug. Inspect both input and output cords for any damage before using the charger.

• Never unplug a cord by pulling on the cord itself. Always grasp the plug when disconnecting the charger.

• For indoor use only. Do not expose charger to rain, snow or excessive moisture.

• Never charge a frozen battery.

• The battery must be placed in a well-ventilated area during charging.

• Do not use the charger while the equipment is operating.

Note: Check maximum Amp input rating of battery. Using a charger with an amp output that is too high may cause permanent damage. input rating of battery.

Please Notice

• Compatible for Lithium Battery (Li-on Battery) and the battery capacity is 36V.

• NOT fit for Razor scooter and dirt bike! NOT fits the model number: LBW11 scooter.

Usage Process

1. Check the voltage and connector of your battery. 2. Connect the charger to AC, LED turns GREEN. 3. Connect DC output to Battery. LED turns RED means fast charging. 4. LED turns GREEN from RED means battery full charged. 5. Disconnect the charger from AC and battery.

• If your scooter is not charging, it may be for one of the following reasons:

1. The charger is not compatible with your scooter.

2. Your battery is damaged due to the limited life of lithium batteries. If your battery has been used for more than 12 months or has not been used for 2-3 months, your battery may be damaged.

3. If the green light is on when you plug in the charger, but when you connect the scooter, the green light does not turn red but stays on and the charger does not work. This is because the positive and negative (+/-) connectors of our charger do not match the positive and negative (+/-) connectors of your scooter and your scooter has no power, you can try to connect the charger to your scooter from a different connector.

4. If the green light is on when you plug in the charger, but goes off when you connect the scooter, it's because the internal short circuit of the scooter has caused the self-protection function of the charger to fail, you'd better check the scooter battery and replace it.

5. Don't use for Lead Acid battery.